1/1

DECORATIVE FINE PLASTER

STANDARD: Conforms to TS 7847.

TECHNICAL SPECIFICATIONS

  • Flexural strength: ≥ 1,5 N/mm2

  • Compressive strength: ≥ 3 N/mm2

  • Period for getting into use: 2 hours

  • CO permeability: CO

  • Cack bridging:    A0

  • Heat-activated thickness: E5

  • Grain size: S4

  • Water-vapour transmission rate: V0

  • Water transmission rate: W0

  • Manner of application: Steel trowel

  • Color:     White

  • Packing: 20 kg bag

PREPARATION

  • The surface to be applied should be free of anti-sticking agents (mould oil, paint, powder, watery surface) and should be firm.

  • The painted surfaces should be made adsorbent via indentation.

  • Flaws on the application surface should be corrected and gauged with Izodress repair mortar.

  • The surface should be moistened before application.

USAGE AND APPLICATION

  • 20 kilograms of fine-textured decorative plaster should be poured slowly onto 5.5-6.5 liters of clean water and preferably mixed with a low-speed mixer (lower than 500 rpm) to obtain a homogeneous admixture.

  • After the first admixture, the mortar should be rested for 5-10 minutes and mixed again for 1-2 minutes before application.

  • The prepared mortar is applied with a steel spud in equal thickness to the surface.

  • Thickness of the application should be adjusted in proportion to the largest grain size in the admixture.

  • The surface of the application should be designedvia circular movements with a plastic spud.

  • The spud surface should be cleaned often while creating patterns.

  • Patterns should be done when the material is wet.