1/2

ECOLOGICAL CEMENT

FINISHER

TECHNICAL SPECIFICATIONS

  • Application temperature: +5 / +30 degree of temperature

  • Consumption: 4,5 / 5,5 kg/m2 (1 cm thickness)

  • Heat conductivity: T1 0,063

  • Sound insulation: (db) 20-44 dB Frequency variant

  • Reaction to fire: A1

  • Pressure resistance: CS2

  • Walkable period: 24/48 hours

  • Waiting for other application: 7-10 days

  • Dry bulk density: 450±50 kg/m3  (1 cm thickness)

  • Heat insulating requirement: None

  • Manner of application: Steel trowel / plaster pump

  • Color:    Grey

  • Packing: 13 kg bag

PREPARATION 

  • The surface to be applied should be free of anti-sticking agents and be firm.

  • Flaws on the application surface should be corrected and gauged with Izodress repair mortar.

  • The surface should be swept for de-dusting.

  • Primer should be applied on highly absorbent surfaces.

USAGE & APPLICATION

  • Firstly, 13-15 liters of water is put into a mortar board of at least 50 liters and then 13 kg of Izodress natural insulation plaster is poured in.

  • The mortar board that is prepared for mixing should be thoroughly cleaned and at the time of mixing, the edges of the mortar board should be scraped thoroughly with the help of a spud and mixed again.

  • For a homogenous admixture, 500-600 rpm mixer should be used. Mixing time is about 2 minutes.

  • After admixture is rested for approximately 5 minutes, it is mixed again for 1 minute before application.

  • If the material starts setting due to delay during application, it should be mixed for thickening again without water and continued to be applied.

  • The prepared mortar should be used within an hour. The laths, which will determine the thickness of Izodress natural insulation plaster, are assembled with appropriate intervals in order to perform smooth plastering.

  • Izodress natural insulation plaster, which is prepared, is filled with plaster shovel and spud between laths.

  • 13-15 liters of water with Izodress natural plaster is added to the machine tank considering the machine capacity for the applications done via machine.

  • After acquiring a homogenous admixture, it is sprayed between the plaster laths for application.

  • Another method is to feed the machine with the product mixed in the mortar boards and spray it between the laths.

  • When the product completes the pre shrinkage (without drying), the laths are removed.

  • Then the gaps between the laths are filled with Izodress natural insulation plaster, and they are corrected by a knife gauge and made ready for the finish coat